The ER-2006 floor controller provides 8 inputs and outputs. All necessary call inputs, as well as arrow outputs, including for selective door control, are available. The installation of the floor controller is carried out in the shaft cable channel. The blue RJ-45 cable and a power cable are used as the bus connection.

The ER-2009 floor controller offers 16 inputs and outputs (6 of which are freely assignable), two piezo buzzer outputs for call acknowledgment, 8 outputs for controlling display panels, 4 outputs for floor gong speakers, as well as the connection option for two bus matrix displays and 1x RJ-12 for TFT graphic displays. All necessary call inputs and arrow outputs, even for selective door controls, are available. The floor controller is installed in the shaft cable duct. The connection cable for the bus is the blue RJ-45 cable, along with a power cable. The lower 7-pin connector with the call lines 2xA & 2xB is intended for door side 1, while the upper connector with 2xC & 2xD is for door side 2. The matrix displays are connected using the RJ-12 cable into the two black sockets.

The floor controller ER-2007 provides 8 inputs and outputs. All necessary call inputs, as well as arrow outputs, even for selective door controls, are available. The installation of the floor controller is carried out in the shaft cable duct. The blue RJ-45 cable is used as the connection cable for the bus. There is the possibility to connect two bus matrix displays. All necessary call inputs, as well as arrow outputs, even for selective door controls, are available. The lower 7-pin connector with call lines 2xA & 2xB is intended for door side 1, while the upper connector with 2xC & 2xD is for door side 2. The matrix displays are connected using the RJ-12 cable into the two black sockets.