ER-2013 Floor Controller
The floor controller ER-2013 offers 8 inputs and outputs. All necessary call inputs, as well as arrow outputs, even for selective door control, are available.
The installation of the floor controller is done in the shaft cable channel. The connection cable for the bus is the blue RJ-45 cable. There is the possibility to connect two bus matrix displays and 1x RJ-12 for TFT graphic displays.
All necessary call inputs, as well as arrow outputs, even for selective door control, are available.
The lower 7-pin connector with the call lines 2xA & 2xB is intended for door side 1, the upper connector with 2xC & 2xD is for door side 2. The matrix displays are plugged into the two black sockets with the RJ-12 cable.
The standalone RJ-12 socket is for high-quality TFT graphic displays with KW bus connection.
| Name of the assembly group: | ER-2013 |
|---|---|
| Use function: | The floor controller ER-2013 provides 16 inputs and outputs. All necessary call inputs, as well as arrow outputs, even for selective door control, are available. |
| Obsolete component: | ER-2001 |
| Time of use: | From 2013 - 2022 |
| Relay elements: | None |
| Dimensions (with shell): | (length x width x height) 130 mm x 46 mm x 30 mm |
| Weight: | Approx. 200 gram |
| Power supply: | Terminals 200 - 24V DC
Terminals 500 - 0V GND |
| Switching cycles: | None |
| Protection level: | IP 43 / Degree of pollution II |
| Place of installation: | In the elevator shaft - cable channel |
| Ambient temperature: | 0 to +45 °C |